Syma X5C-1 Rotor Problem

Discussion in 'Specific Models of Quadcopters and Drones' started by Luke Smith, Aug 11, 2015.

  1. Luke Smith

    Luke Smith New Member

    Hi Guys,

    I have a Syma x5c-1. I accidently flew it into a washing line and the propeller got slightly stuck but it then fell to the ground.
    What I do not get is that currently whenever the drone turns on one of the motors will come on as well for around a second before going off (this is without any throttle). When flying it the same propeller will randomly shoot to full power causing the drone to til to the right. Then when landing and all the other motors are off the same one will shoot to full power again and cause the drone to flip to the right.

    I have taken the case of and there doesn't appear to be any lose cables or anything. Considering the motor actually comes on and spins fine I am assuming this is not the cause of the issue? Would I need to get a replacement part and if so which one?

    Thanks for the assistance.
  2. Ton van den Berg

    Ton van den Berg New Member

    Hi Luke,

    I guess you're motor has a short-circuit. You can replace it easily and then it should work.

    Good luck,

    Ton van den Berg

Share This Page